wasn't too hard, just had to find the different polarities since there is a three position switch on the light and run it off the correct ones on the circuit board.
From there I just ran an extra length of wire to the opposite side of the fixture and trimmed down some of the metal spacer so I could mount the LED against the light since the thickness of the LED fits the housing perfectly but only if the board and reflector/spacer is pushed to one side.
From there I just ran an extra length of wire to the opposite side of the fixture and trimmed down some of the metal spacer so I could mount the LED against the light since the thickness of the LED fits the housing perfectly but only if the board and reflector/spacer is pushed to one side.
Comment