My used 125 sprung a small leak in the lower left corner when the stand was hit. After trying to find someone to re-seal it for me I decided to try it myself. I thought everything went well, removed and cleaned off all the old silicone, and although it wasn't pretty I thought I did a decent job of ensuring a good, although thick, re-seal.
This morning I woke to find some small air bubbles on the 2 right side seals.
I really don't want to remove and re-do it all, my questions are -
Will the bubbles be okay? (pics of the areas in question attached here I hope)
If I do need to remove the bad sides, do I have to re-do the Whole tank or can I do just the 2 sides without the bottom?
Thanks in advance for any help. I'm at the point where if this needs to be re-sealed I'm going to get rid of it!
This morning I woke to find some small air bubbles on the 2 right side seals.
I really don't want to remove and re-do it all, my questions are -
Will the bubbles be okay? (pics of the areas in question attached here I hope)
If I do need to remove the bad sides, do I have to re-do the Whole tank or can I do just the 2 sides without the bottom?
Thanks in advance for any help. I'm at the point where if this needs to be re-sealed I'm going to get rid of it!
Comment