If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Unfortunately I needed to pull the trim off so that I can get my 3d background put into it. They wanted to send me a better background so I returned the old one and am waiting on the new one to come in. I can't wait!!
Yes, in-wall sheeting foam insulation is what you need. Â Try to get stuff that will spring back when you compress it with your fingers instead of the cheap stuff that just stays compressed.
I bet your tank appreciates that cozy touch! Â j/k
Ellen
yeah, the little guys wanted a tempurpedic mattress, but had to settle for the fleece instead
Seriously, I have heard about using the foam insulation as leveling material and will try it myself the next opportunity I have. Â Old house on pier and beam, different doors open and close, or not, each day.
Reasoning with some people is like trying to nail jello to a wall...
  I'm still waiting on shipment of a couple of things for the behind the scenes stuff before I can put the tank in for good and install the trim. The tank is in there so I can see what it's going to look like and it's AWESOME!
If that is  load bearing wall ,Iwould suggest some "fire breaks/ bridging" between the studs. Also you can never go wrong with insulation in the walls. It looks to me like you are going to build a tank into an existing alcove, not the actual wall; did I miss some thing ?
I had to add a room behind the garage in order to build a 135 into the wall between room and garage. I accessed from both sides with panels hinged at the ceiling. I have interesting 3rd dimension supports to the garage ceiling. Â If I could internet as well as nail I would post photos.
And it would be a good time to put in an outside combustion air duct from the attic to the fireplace : in case you have any free time.
haha, well, it's a little late for any of that, but no, it's not a load bearing wall. When I first started I thought it might be, but no worries there. Yes, it was an existing cove.
Thanks for the journal. I too will soon (hopefully) be doing something similiar and have been watching with interest. The only real difference on mine is that I won't have any rear access, so instead of it being built into the wall, I will build it into the alcove and then have ceiling hinged panels to access the tank. I have been doing some thinking on the leveling thing and have come up with this:
Form a lip (about a 1/4" to 3/8") around the top of the stand. I will build this into mine since the back and both side walls will be part of the alcove and I will bring the cabinet front about 1/2" above the top of the stand. Then use self-leveling floor compound on top of the stand. This will not only insure that you have a flat surface, but it will give you a level surface also. I will then lay a 1/4" sheet of plywood on top of that. With a 1/4" of floor leveler and 1/4" of plywood I will then be even with the cabinet front.
I'm actually looking into buying a house now, so this may be an option for me in the near future, plus I like the idea of making a custom size tank so it could be a combo feature for me.
Comment