little spec V new pic 3/13/2013

[johnnytrinh]

Yeah I thought about that after I had glue them down. Might just use this set up for my 40g. Everything is solder on the blue works perfectly. But the white flashes when it's under about 75% power.

[johnnytrinh]

[eklikewhoa]

Do you have them on seperate drivers?
Which driver/power supply do you have on each?

[johnnytrinh]

7 Rb on one driver. 4 white and 2 uv on the other. Maxwell driver. It says 7-12 led on a driver. I got 6. Would that be a problem?

[eklikewhoa]

The uv being on the same as the white. What's the ratings of the two?

[johnnytrinh]

I'm not sure of the rating.

[eklikewhoa]

Probably want to look that up wherever you got them, from what I have come across on the web is that you want the UV and Blue on one if you must have two on one and then the whites on their own. Also noticed that most sites have their UV rated for a lower max drive current and lower forward voltage

[johnnytrinh]

If I put the uv with the blue will the driver be too much for just 4 white? It recommends 7-12 led per driver. Will email them tomorrow

[eklikewhoa]

You have a better picture or maybe draw it out on paint or on a paper then take a pic of how you have it wired

[New2petro]

Seems like this is becoming more of a project then expected. Good luck, I'm sure you will get it where you want it.

[johnnytrinh]

Ill draw it out tomorrow.

[johnnytrinh]

Got it fixed!! Had email them and they said it has to be 7-12 led per driver. So I added another white. Everything works perfectly now.

Lowest power


50%


full power

[johnnymisty]

Leds look good. Nice build

[johnnytrinh]

Leds look good. Nice build

Thanks. Happy with everything and how it looks. Got to clean up all the wiring now.

[johnnytrinh]